Application and Washing Instructions :: Glow Flex

Application temperatures and heat pressing times are only a guide and can vary depending on material content.  

It is therefore recommended that you do an evaluation on test material first.

• Prepare design and cut in mirror
• Select medium speed on plotter depending on type and make
• Use standard plotter blade and adjust the offset accordingly
• Set heat press to 150^oC 
• Set press pressure to low / medium
• To aid application and to eliminate creasing, lay down garment onto base platen and press for 3-5 seconds
• Open press and place the cut and weeded design at correct location on the garment (polyester liner up)
• We recommend at this point to cover the design with a sheet of Tygaflor or a silicon sheet
• Press for 15 seconds. 
• Open Press slowly and remove garment. Remove polyester liner while still hot.

It is recommended that you wait 24 hours after heat applying and turn the garment inside out before washing.

DO NOT iron directly over the decal. Turn the garment inside out and iron from the back.