Application and Washing Instructions :: D Print Laser Dark
Pro-flex appins
Application temperatures and
heat pressing times are only a
guide and can vary depending on material content.
It is therefore recommended
that you do an evaluation on test
material first.
Application
and Washing Instructions:
Printing &
Plotting
/ Cutting
Print Format
Cuttable by hand
Regular
Yes
Heat Pressing
Material
Temperature
Press Time
Pressure
Peel
Cotton
120oC
- 130oC
10 - 15 secs
Medium
N/A
Polycotton
120oC
- 130oC
10 - 15 secs
Medium
N/A
Polyester
120oC
- 130oC
10 - 15 secs
Medium
N/A
Application:
Print design in
regular format (not
mirrored) onto the rough, coated side using single sheet feed only
Set printer to Thick / Heavy
stock mode and increase toner levels and colour brightness
Trim away any unprinted
paper around the image with scissors or a scalpel
Remove the backing paper
from the transfer film.
This can be done either by carefully using a scalple blade to
get
the corner seperated or by slightly tearing the paper about 3mm in one
of the images lighter areas to seperate.
Once this has been done
remove the backing paper
completely and position image onto garment printed side facing up
Cover the image with a
silicone sheet and press according
to the material selected (see table above)
Allow silicon sheet to cool
before removing. If
this is peeled warm some of the image may transfer to the silicon sheet
Aftercare:
It is recommended that the
garment is turned inside out before
washing.
Washing
Temperature
Spin
Tumble Dry
Dry Clean
Up to 40oC
No
No
No
Ironing:
DO
NOT iron directly over the
decal. Turn
the garment inside out and iron from the back or cover with a silicon
sheet.