Application and Washing Instructions :: D Print & Cut Dark
Pro-flex appins
Application temperatures and heat pressing times are only a
guide and can vary depending on material content.
It is therefore recommended that you do an evaluation on test
material first.
Application and Washing Instructions:
Printing & Plotting
/ Cutting
Print Format
Plotter Blade Type
Cuttable by hand
Cutting Pressure
Regular
Standard vinyl blade
Yes
Medium
Heat Pressing
Material
Temperature
Press Time
Pressure
Peel
Cotton
190oC
30 secs
Medium
N/A
Polycotton
190oC
30 secs
Medium
N/A
Polyester
190oC
30 secs
Medium
N/A
Application:
Print design in regular format (not
mirrored) onto the rough, coated side using single sheet feed only
For best results use a high resolution or photo quality
print setting
Trim away any unprinted paper around the image
Remove the backing paper from the transfer film.
This can be done either by carefully using a scalple blade to
get
the corner seperated or by slightly tearing the paper about 3mm in one
of the images lighter areas to seperate.
Once this has been done remove the backing papaer
completely and position image onto garment printed side facing up
Cover the image with a silicone sheet and press according
to the material selected (see table above)
Allow silicon sheet to cool before removing. If
this is peeled warm some of the image may transfer to the silicon sheet
Aftercare:
It is recommended that the garment is turned inside out before
washing.
Washing
Temperature
Spin
Tumble Dry
Dry Clean
Up to 40oC
No
No
No
Ironing:
DO NOT iron directly over the decal. Turn
the garment inside out and iron from the back or cover with a silicon
sheet.