Application and Washing Instructions :: Pro-flex Plus

Application temperatures and heat pressing times are only a guide and can vary depending on material content.  

It is therefore recommended that you do an evaluation on test material first.

Application and Washing Instructions:

• Prepare design and cut in mirror
• Select medium speed on plotter depending on type and make
• Use recommended plotter blade and adjust the offset accordingly
• Set heat press to either 155^oC - 165^oC or 140^oC - 150^oC depending on material used(see above)
• Set press pressure to medium
• To eliminate creasing, lay down garment onto base platen and press for 3-5 seconds
• Open press and place the cut and weeded design at correct location on the garment (polyester liner up)
• We recommend at this point to cover the design with a sheet of Tygaflor or a silicon sheet
• Press for 15-20 seconds. 
• For garments with a high synthetic content, lower the heat press temperature and pressure, whilst extending the press time
• Open Press and remove polyester liner after either 3-5 seconds or 10 seconds + depending on material used (see above) and then press garment again for a further 3 seconds covered with a silicon sheet. (*)
• Open Press and remove garment. 

It is recommended that the garment is turned inside out before washing.

DO NOT iron directly over the decal. Turn the garment inside out and iron from the back.