Application and Washing Instructions :: Nylo-flex Plus

Application temperatures and heat pressing times are only a guide and can vary depending on material content.  

It is therefore recommended that you do an evaluation on test material first.

Application and Washing Instructions:

• Prepare design and cut in mirror
• Select medium speed on plotter depending on type and make
• Use standard plotter blade and adjust the offset accordingly
• Set heat press to 145^oC - 150^oC
• Set press pressure to medium
• To aid application and to eliminate creasing, lay down garment onto base platen and press for 3-5 seconds
• Open press and place the cut and weeded design at correct location on the garment (polyester liner up)
• We recommend at this point to cover the design with a sheet of Tygaflor or a silicon sheet
• Press for 3 seconds then remove the polyester film while still warm. 
• After cooling down the material is to be re-pressed for a further 10-15 secs.

It is recommended that the garment is turned inside out before washing.

DO NOT iron directly over the decal. Turn the garment inside out and iron from the back.